After carving the handled I tested the smaller of the two spoon
bits on a piece of bone. There was no effect on the bone and the tip of
the bit bent. After some discussion with the smith I believe the metal
was hammered to thin. Another possible problem is the metal for the
smaller bit as different than the metal used for the other two bits and
may not have taken the hardening processed as well. He is going to make
another small spoon bit using a better grade of steel.
I am looking at other shapes of bits that may be usable for drilling holes in the bone. I
am going to cut the thinner parts of the bit off and sharpen what is
left into a slightly different shape to see how well it will drill a
hole. If all else fails the spoiled bit will get turned into an awl that can be used to create starter holes in wood, leather, or even heavy fabric. Either way the work on the bit and the handle will not be wasted.
A place to share my efforts in Illumination, Nalbinding, and everything else SCA Arts and Sciences related.
Translate
Total Pageviews
Showing posts with label spoon bit. Show all posts
Showing posts with label spoon bit. Show all posts
Saturday, 19 April 2014
White Wolf Fian: Ring and Dot Tool & Hand Drill Bit
To sharpen the tools I used a small set of files to give the edges the correct bevel of about 22º. Then I used oil and wet stones to give them their final sharpening.I tried them on a piece of birch after I sharpened them and found they worked well on wood. The tests on bone did not yield the best results.
To remedy this problem I am putting cherry handles on the tools. I started with rectangular blocks of cherry wood. So far I have shaped the wood down to create a wide based for my palm to pres against while the handle near the working end of the tool narrow enough for me to see what I am doing during use. Once the handles have been sanded smooth I will seal them with a coat of polyurethane so they last a very long time.
Subscribe to:
Posts (Atom)